How do I install the quarter round for my laminate floors?
Do I use a hammer and nails, or a nail gun, or is there some adhesive I need to buy? Also, how do I cut it?
You can use any of those methods. A brad nailer works faster and easier. If the laminate is a floating floor, only connect to the wall and not the flooring. A miter saw works best for cutting the proper angles on the trim.
Hey everyone, Rob here.
Thanks for stopping by. My wife had been nagging me for months to get new flooring for our home, but everything was just too expensive.
After doing some research online I found a course that showed how to install laminate flooring start to finish.
I watched the course and used the methods, and believe it or not saved over $1,000 on this project. (Heck, it wasn't even that hard!).
Read my story to the left for more information.
Have a good one,
Rob